- 1. That applies to all industries and in almost filter can be pleat equipment. Due to pleating by four cams, it can pleat normal filter, several layers filter, AL, Steel Mesh.
→Use for Media : Paper, Mesh, Non Woven Cloth, Electronic Media, Synthetic Media, PTFE Media
- 2. Minimize the friction by Teflon Coating
- 3. The post heating intervals is 500mm. It has been increased the time and space. So it has been improved the quality of production.
→Input Heater System of Heating Length: 250mm. Outlet Heater System of Heating Length: 500mm.
- 4. Automatic setting function for pleating height.
- 5. Can pleating W-TYPE. (Special Feature)
- 6. ION BLOWER installation (Minimize the static buildup between a reciprocate pleater and the material.)
- 7. Safety Guard system of Door and Cover
- 8. Touch Screen Controller
- 9. Production Speed Control : Inverter
- 10. Heater System : When the temperature goes up or down above ±2 degrees than the set temperature, the power is cut off.
- 11. Marking system : On the top of the outlet part.
- 12. Individual use is also available.
- 13. Blade Stop : It was designed to stop when the lower blade reaches to the rising point.
- 1.Media Change : Lift system
- 2.Media holding : 3 inch Air Expansion Shaft
- 3.Media Tension Control : Powder Brake system
- 4.Media feeding speed control : Fiber Sensor
- 5.The upper feed roller: Rubber coating
- 6.Cutter : 4 sets
- 7.Slit Cutter : Air cylinder type.
- 8.Electric Power : 380V/220V * 60HZ *3P
- 9.Motor drive capacity : 0.40kW
- 10.Use the media:
* Width - 650, 950, 1250, 1550mm
* Out Diameter - 1000mm / Max.
* Weight – 150kg / Max.
- 1. HEPA Pleater use Hot-melt adhesive while it pleat. Depending on the amount of hot-melt, can increase or decrease the pitch of pleated.
- 2. Development of a variety of hot melt spraying method. (5 kinds of hot melt spraying method)
- 3. It can control to height through the input values without exchange the roller.
- 4. Automatic height adjustment of the outlet conveyor can be set up through the numeric input.( When pleating height is adjusted, can be adjusted simultaneously.)
- 5. In order to increase a worker's convenience, installed a moving remote operating panel.
- 6. Media Change : Lift system.
- 7. Media holding : 3 inch Air Expansion Shaft.
- 8. Media Tension Control : Powder Brake system
- 9. Slit Cutter : Air cylinder type
- 10. Cutter : 4 sets
- 11. Use the media: ULPA, HEPA, Medium
- 12. Module Assembly : Each conrol.
- 13. Hot-melt pitch : 25.0mm (1 inch 25.4mm – Option)
- 14. Both sides Melting system..
- 15. Media feeding control : Fiber Sensor
- 16. Air Cooling Pressure Control : Inverter system
- 17. Idle Roller : Teflon Coating
- 18. Safety Guard system of Door and Cover
- 19. Color Sensor : Hot-melt position Control – Synthetic, PTFE Media
- 20. Touch Screen Controller